Memory BAT mapping: BAT2=256Mb, BAT3=0Mb, residual: 0Mb
Total memory = 256MB; using 1024kB for hash table (at c0400000)
Linux version 2.4.19-4a (root@kaelta.terraplex.com) (gcc version 2.95.4
20010319 (prerelease/franzo/20011204)) #1 Wed Jun 5 01:34:59 EDT 2002
Found Uninorth memory controller & host bridge, revision: 17
Found a Keylargo mac-io controller, rev: 3, mapped at 0xfdebf000
Processor NAP mode on idle enabled.
PowerMac motherboard: PowerMac G4 Silver
Found UniNorth PCI host bridge at 0xf0000000. Firmware bus number: 0->0
hose pci, pci_mem_offset: 00000000, start0: f1000000
io_base_virt: fd6bc000, io_base_phys: f0000000, isa_mem_base:
00000000
Found UniNorth PCI host bridge at 0xf2000000. Firmware bus number: 0->0
hose pci, pci_mem_offset: 00000000, start0: f3000000
io_base_virt: fceba000, io_base_phys: f2000000, isa_mem_base:
00000000
Found UniNorth PCI host bridge at 0xf4000000. Firmware bus number: 0->0
hose pci, pci_mem_offset: 00000000, start0: f5000000
io_base_virt: fc6b8000, io_base_phys: f4000000, isa_mem_base:
00000000
PMU driver 2 initialized for Core99, firmware: 0c
On node 0 totalpages: 65536
zone(0): 65536 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: root=/dev/hda4 hdc=ide-scsi
ide_setup: hdc=ide-scsi
PowerMac using OpenPIC irq controller
OpenPIC Version 1.2 (4 CPUs and 64 IRQ sources) at fc671000
OpenPIC timer frequency is 4.166666 MHz
open_pic.c debug: NumSources == 40
GMT Delta read from XPRAM: -360 minutes, DST: off
time_init: decrementer frequency = 33.290001 MHz
Console: colour dummy device 80x25
Calibrating delay loop... 930.61 BogoMIPS
Memory: 253664k available (2660k kernel code, 1072k data, 324k init, 0k
highmem)
AGP special page: 0xcffff000
Dentry cache hash table entries: 32768 (order: 6, 262144 bytes)
Inode cache hash table entries: 16384 (order: 5, 131072 bytes)
Mount-cache hash table entries: 4096 (order: 3, 32768 bytes)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
POSIX conformance testing by UNIFIX
PCI: Probing PCI hardware
Scanning bus 00
Found 00:58 [106b/002d] 000600 00
Found 00:80 [1002/5046] 000300 00
Fixup res 1 (101) of dev 00:10.0: 400 -> 802400
Fixups for bus 00
Bus scan for 00 returning with max=00
Scanning bus 01
Found 01:58 [106b/002e] 000600 00
Found 01:b8 [106b/0022] 00ff00 00
Found 01:c0 [106b/0019] 000c03 00
Found 01:c8 [106b/0019] 000c03 00
Fixups for bus 01
Bus scan for 01 returning with max=01
Scanning bus 02
Found 02:58 [106b/002f] 000600 00
Found 02:70 [11c1/5811] 000c00 00
Found 02:78 [106b/0021] 000200 00
Fixups for bus 02
Bus scan for 02 returning with max=02
PCI->OF bus map:
0 -> 0
1 -> 0
2 -> 0
PCI:00:10.0: Resource 0: 94000000-97ffffff (f=1208)
PCI:00:10.0: Resource 2: 90000000-90003fff (f=200)
PCI:01:17.0: Resource 0: 80000000-8007ffff (f=200)
PCI:02:0f.0: Resource 0: f5200000-f53fffff (f=200)
PCI:00:10.0: Resource 1: 00802400-008024ff (f=101)
PCI:01:18.0: Resource 0: 80081000-80081fff (f=200)
PCI:01:19.0: Resource 0: 80080000-80080fff (f=200)
PCI:02:0e.0: Resource 0: f5000000-f5000fff (f=200)
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Thermal assist unit using timers, shrink_timer: 200 jiffies
Starting kswapd
VFS: Diskquotas version dquot_6.4.0 initialized
Journalled Block Device driver loaded
devfs: v1.12a (20020514) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x0
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
udf: registering filesystem
PCI: Enabling device 00:10.0 (0086 -> 0087)
aty128fb: Rage128 Pro PF (AGP) [chip rev 0x1] 16M 128-bit SDR SGRAM
(1:1)
Console: switching to colour frame buffer device 128x48
fb0: ATY Rage128 frame buffer device on PCI
input0: Macintosh mouse button emulation
pty: 256 Unix98 ptys configured
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with
idebus=xx
pmac_ide: enabling IDE bus ID 2
pmac_ide: enabling IDE bus ID 0
pmac_ide: enabling IDE bus ID 1
hda: IBM-DTLA-305030, ATA DISK drive
hdc: SONY CD-RW CRX140E, ATAPI CD/DVD-ROM drive
ide0 at 0xd520b000-0xd520b007,0xd520b160 on irq 19
ide1 at 0xd520f000-0xd520f007,0xd520f160 on irq 20
hda: Enabling Ultra DMA 4
ide_pmac: Set UDMA timing for mode 4, reg: 0x0c50038c
hda: 60036480 sectors (30739 MB) w/380KiB Cache, CHS=59560/16/63,
UDMA(66)
ide-floppy driver 0.99.newide
hdc: Enabling MultiWord DMA 2
ide_pmac: MDMA, cycleTime: 120, accessTime: 90, recTime: 30
ide_pmac: Set MDMA timing for mode 2, reg: 0x00011d26
Partition check:
/dev/ide/host0/bus0/target0/lun0: [mac] p1 p2 p3 p4
RAMDISK driver initialized: 16 RAM disks of 16384K size 1024 blocksize
loop: loaded (max 8 devices)
sungem.c:v0.97 3/20/02 David S. Miller (davem@redhat.com)
eth%d: MII PHY ID: 206050 BCM 5401
eth0: Sun GEM (PCI) 10/100/1000BaseT Ethernet 00:30:65:cb:ca:38
PPP generic driver version 2.4.2
PPP Deflate Compression module registered
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory: 204M
agpgart: Detected Apple UniNorth 1.5 chipset
agp: configuring for size idx: 4
agpgart: AGP aperture is 16M @ 0x0
ide-floppy driver 0.99.newide
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
Vendor: SONY Model: CD-RW CRX140E Rev: 1.2a
Type: CD-ROM ANSI SCSI revision: 02
mesh: configured for synchronous 5 MB/s
Attached scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0
sr0: scsi3-mmc drive: 32x/32x writer cd/rw xa/form2 cdda tray
Uniform CD-ROM driver Revision: 3.12
Linux Kernel Card Services 3.1.22
options: [pci] [cardbus] [pm]
Intel PCIC probe: not found.
macserial: i2c-modem detected, id: 1
PowerMac Z8530 serial driver version 2.0
ttyS0 at 0xd22db020 (irq = 22) is a Z8530 ESCC (internal modem)
ttyS1 at 0xd22e2000 (irq = 50) is a Z8530 ESCC
Macintosh non-volatile memory driver v1.0
apm_emu: APM Emulation 0.5 initialized.
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
PCI: Enabling device 01:18.0 (0000 -> 0002)
PCI: Enabling bus mastering for device 01:18.0
usb-ohci.c: USB OHCI at membase 0xd22e8000, IRQ 27
usb-ohci.c: usb-01:18.0, Apple Computer Inc. KeyLargo USB
adb: starting probe task...
adb: finished probe task...
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
PCI: Enabling device 01:19.0 (0000 -> 0002)
PCI: Enabling bus mastering for device 01:19.0
usb-ohci.c: USB OHCI at membase 0xd22ea000, IRQ 28
usb-ohci.c: usb-01:19.0, Apple Computer Inc. KeyLargo USB (#2)
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
hub.c: 2 ports detected
usb.c: registered new driver hid
hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik
hid-core.c: USB HID support drivers
mice: PS/2 mouse device common for all mice
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
ds: no socket drivers loaded!
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 324k init 8k chrp 8k prep
hub.c: USB new device connect on bus2/1, assigned device number 2
hub.c: USB hub found
hub.c: 3 ports detected
hub.c: USB new device connect on bus2/1/1, assigned device number 3
input1,hiddev0: USB HID v0.01 Keyboard [Alps Electric Apple USB
Keyboard] on usb2:3.0
hub.c: USB new device connect on bus2/1/2, assigned device number 4
input2,hiddev0: USB HID v10.01 Mouse [Fujitsu Component Apple Optical
USB Mouse] on usb2:4.0
Adding Swap: 524268k swap-space (priority -1)
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
NET4: Linux IPX 0.47 for NET4.0
IPX Portions Copyright (c) 1995 Caldera, Inc.
IPX Portions Copyright (c) 2000, 2001 Conectiva, Inc.
NET4: AppleTalk 0.18a for Linux NET4.0
eth0: MII PHY ID: 206050 BCM 5401
eth0: Link is up at 10 Mbps, half-duplex.
eth0: Pause is disabled